To replace your handlebars

Although we have our cars and motorcycles, there is nothing better than an early morning ride on our bikes or stroll in the evening. If our bike needs minor repairs and replacements, you can easily do yourself, but often is not very complicated. One thing is instead of the handlebar. Under normal circumstances, when the vines are in good condition, should take less than 15 minutes to remove the old and new trunkone.

Here are some step by step instructions and suggestions to replace your head:

1. First, you must purchase the right rod for your requirement. You can strains of different length and are between 35 and 135 mm. When you purchase the master for the driver you have to go with the right size of the head tube so that should not be performed for an exchange.

2. Remove the headset top cap.

3. The removal of the bolt front load, this is a 4 mmBolts. The bolt preload, which helps to adjust the headset.

4. You can find a total of five 5 mm screws and the panel on the steering tube. There are four front and one on the back of the front panel.

5. Remove the four screws to come loose before the first on the back.

6. Remember, bolts, cap cap to keep everything in one place, because you do not want the hunt for the start and 40 minutes spent on research as we would likejust 15 minutes to replace the whole tribe. Do not overlook this point.

7. After removing all the screws, remove only stem from the fork. During pull out, you can easily remove if you do not pull into a corner, but at 180 degrees on the fork.

8. Once you remove the old root, it is necessary to establish the new porch. While the creation of new stem cells begin to bolt back to the first. This ishold the handle firmly in position on the handlebar stem.

9. Place the arm in place and the faceplate so as to properly align the screw holes can enter without difficulty.

10. Some are connected with the scoring for the perfect fit. So look for the markers.

11. Start by entering the arm in position, tighten the 4 screws on the front panel of five millimeters. When tightening should be notedEach bolt does not come back before the next excited. All four screws must be tightened evenly to avoid future problems. Normally, the screws are tightened in diagonally opposite turn. This is something that should not be overlooked.

12. Now check that your arm position requires minor changes and adjustments necessary before tightening the four screws completely. Upon completion, tighten the bolts to replace the pre and the loadHeadset cap.